Using the tech support team instruction you’ll be able to perfectly setup and configure the Wireless-G router. Initially you need to connect the Wireless-G router for the cable modem. You need to turn off both Linksys Wireless-G router as well as the cable modem before going onto connect them. Take one finish in the Ethernet cable and hook it up towards the cable modem. Now you must to insert another finish in the Ethernet cable to the port known as Internet. There’s a port behind side panel in the Wireless-G router. Searching with this particular won’t be that difficult as it is located just close to the power port in the router.
Now you must for connecting the Wireless-G router for the laptop. The tech support team experts always warn to show off laptops before inserting the primary one finish in the Ethernet cable to the laptops’ Ethernet port. Another finish in the Ethernet cable was already connected with Wireless-G router. Most often the Ethernet port is around the rear side in the laptop but surely it might vary from manufacturer to manufacturer. Make certain that Ethernet cable is positioned inside the right port. Be conscious so it should not go to the dial-up modem port.
Now you must to plug round the cable and switch around the cable modem, your laptop and Wireless-G router. First you need to turn on the cable modem and make sure whether it’s properly connected to the websites provider’s server. Delay until the text is created. It is possible to determine whether the text is created because the status indicator for net connection will blink once the connection is created. Its round the front panel in the cable modem. Now you must to plug the router’s power adapter to the power port in the router’s back panel. Plug the adapter into power.
Now wait not under two minutes to make sure that cable modem may be connected properly for the Wireless-G router. When the light in the router will probably be on you should understand the bond is created. Now you have to change in your laptop. Insert the CD for setup of router and start carrying out a on-screen instructions. Without getting the Setup CD together with you can download it within the support page of Linksys.com.
Using this tech support team instructions you can now go to the default Ip of Wireless G router. The next thing is to change advanced settings. Type “192.168.1.1” inside the address bar once you have opened up up a web browser. Press ‘enter’. Once you are inside the default Ip of Wireless-G router. There’s additionally a dialogues box which contains password. You need to leave the username and wish to type ‘admin’ as password. Click ‘ok’ therefore the setting page for Wireless-G router starts loading.
